Electric RC Helicopter always in fashion. Keeping up with development, many RC giants have started producing electric helicopter models of them. Finally, one of the largest manufacturers, Thunder Tiger, enter the arena. After such a success that their previous line, the "Raptors", a standard in nitro helicopters is set, it's exciting to see if its new model, the "Mini Titan E325" can do the same for electric helicopters.
Revolutionary FrameDesign:
Rc Helicopter
Mini Titan frame design may be the position of the main landing gear and battery as a true revolutionary, the most noticeable change. While most other helicopters of the Convention taken in the placement of main landing gear and the battery below it, the Mini Titan landing gear at the lowest point possible in the frame is positioned. According to experts, this type of configuration results in a much better roll and yaw response.
The battery is the positionHow unique. While most models place the battery in the bottom center, Designer Mini Titan courageously chose to insert the battery in the front of the model - mounted on a tray Battery "L" and suspended at an oblique angle. While some people may think that this type of placement of the battery to upset the general balance of the helicopter, many avid pilots claim that the battery weight balances the weight of the receiver, gyro and the tail pipeCreating a center of gravity of its kind, this helicopter can perform maneuvers exceptionally well.
Main rotor control system:
The Mini Titan adopts a system of control to 120 degree E-CCPM. The swash plate is made of plastic, but even if that is the case, is harder and heavier than most other electric model helicopters. The thrust bearing main grip is the same type used in large scale nitro helicopter 3D gives you precise control step.The swash plate and a red ribbon in the center hub damper. This fact alone is not really worth mentioning, but the band is really high quality and speaks volumes about the impression factor.
Stern Drive unit:
The queue system of the Mini Titan is one that truly throws normal convention out the window. The designers have done a tail boom, which can be removed and assembled to create. This is possible because the tail drive system is isolated. As a result ofassemble and disassemble the tail boom takes less than a minute and requires only one screw - this is already small helicopter allows more than acceptable.
Engine, power steering, position control and speed:
L ', servo motor and controller are all positioned differently from other models. The engine is in a position slightly forward to be related, but it is so close to the center to keep as much as possible to counteract any rotational force. The controller is on the front andlowest point on the frame. This position will be argued that the protection of the force-resistant circuits of the speed in an accident. The regulator and motor are also in a way that allows air, both flying and the rotor arranged to ensure effective heat dissipation. Designer of the Mini Titan also claim that the new positioning of the servants to be mounted in a faster response and more accurate results overall rate.
In flight, the Mini Titan performs exceptionally.With its unique components placement, this helicopter with a focus only one who can answer also is blessed to be stable. Its handling is more precise and agile as that of a helicopter nitro-established as the Raptor. With all of the above, of seeing and testing the Mini Titan in the air is breathtaking. Unlike other electric RC helicopters, which are rated good, this model is one that is truly spectacular. Again, Thunder Tiger does not fail to deliver.
Mini Titan E325 Review
No comments:
Post a Comment